Blufloc Decoloring Agent Water Treatment 30% Water Solution PH Value 3-6 BWD-01

Description:

It has high color removal of ink wastewater, by providing a large number of cations, the negative charge is brought on dye molecules are neutralized instability, at the same time with BWD-01 Water Decoloring Agent by a large number of hydrolysis of flocs. Can be adsorbed dye, destabilization of the snare, from water separation, so as to achieve the purpose of bleaching.

Appearance:

Colorless and Translucid Liquid

Solid Content:

50%min

Viscosity(25°C, cps):

50-300

PH Value (30% Water Solution):

3-6

Specific Gravity (at 20°C):

1.1-1.3

Water Solubility:

Completely Soluble With Water at Any Rate

Package:

30kgs net plastic drum, 250kgs net plastic drum palletized, 1250kgs net IBC drum

Storage Temperature:

Room temperature

1. Very high performance in treating wastewater with Reactive dye, Acid dye, dispers dye, Direct dye, Sulphur dye, Vat dye, etc..(water soluble and insoluble dyestuffs).
2. Published in the 90's, and developed more than 10 years by Bluwat Chemicals.
3. The quality is very stable, and will not change to be layered when the temperature changes.
4. High efficiency of color removal treatment for textile dyeing & printing mills, dyestuffs & pigment mills, and ink & paper making mills wastewater.
5. In paper mills, it is used as a retention agent used in paper and pulp processing, as K97.

1

High-performance treating high-coloring effluent from textile dyeing mills, pigment mills, printing ink, and paper mills.

2

As flocculant to de-color high-coloring effluent from dyestuffs processing plants.

3

Stronger decolorization (50%~99%) and removal of COD (50%~80%).

4

Can be used as a retention agent in paper & pulp processing

5

Faster sedimentation, better flocculation.

6

Non-pollution (no aluminum, chlorine, heavy metal ions, etc.).

7

It can be used before or after biological treatment.

8

Less sludge is produced than other inorganic coagulants.

1

Before use, make BWD-01 with fresh water 40-50 times, to have a 2-2.5% concentration solution.

2

Make PAC solution with 2-5% Al2O3 content.

3

Make a solution of Anionic flocculant with 0.1% concentration.

4

It is very important, to adjust the effluent pH value to 8-10, with higher or lower pH, BWD-01 works not well.

5

Add PAC solution, and mix with effluent completely. about 1-3 minutes

6

Add BWD-01 solution, mix with effluent completely, about 5-10 minutes

7

Add a small content of anionic polyelectrolyte solution, and mix slowly to have a big floc. (This step is a suggestion)

8

Sedimentation

9

Check the color of treated effluent

10

Adjust the dosage of BWD-01 and PAC to do more tests to have better testing results.

1. Packed in 30kgs, 50kgs, 250kgs net plastic drums, and 1250kgs net IBC drums, or others according to the requirements of clients.
2. Suggested to store at room temperature, would show slight stratification or appear white at low temperature, cannot be placed in the sun.